Apache Technologies Bullseye 3 Manual del operador descargar pdf (Pagina 11)

Sequence to

lower implement

Sequence to

raise implement

Operation

Out of Beam Indication. The receiver has an Out Of Beam (OOB)

indication that can be turned on or off. When it is on, the LED display

will

indicate if the receiver has moved beyond the vertical laser

reception range. A sequence of LED's will indicate which direction to

move the blade or cutting edge to pick up the laser beam. The sequence

will indicate to move the edge down if it is raised above the beam or

to move the edge up if it is lowered below the beam. The sequence

will stop as soon as a laser signal is received. Otherwise it will shut off

after two minutes.

Out of Beam Indication On

The factory default setting is Out of Beam Indication on. To turn the

indication off, press the 2 unmarked outer switches at the same time.

The LED display will show a sequence inward toward on-grade when

the indication is on. Pressing both switches again while the indica-

tion is activated will turn the indication off. The LED display will show

a sequence outward from on-grade to conﬁrm the indication is off.

Pressing the switches again while the indication is activated will turn

the indication back on.

Unmarked

outer switch

Unmarked

outer switch

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

Apache Technologies Bullseye 3 Manual del operador Pagina 11