Apache Technologies Bullseye 3 Manual del operador descargar pdf (Pagina 10)

Remote Display

Remote Display Model 14

Operation

Mount the Remote Display in the machine's cab so the operator can

easily see it during machine operation but so as not to obstruct the

view. The Remote Display includes a suction cup mounting kit that

can easily be attached to a smooth surface in the cab. If necessary,

the suction cups can be removed and other user provided hardware

used to secure the display in a convenient viewing location.

Plug the remote cable connector into the remote display power /

communication connector. Run the power cable with terminal ends to

the machine battery. Connect the red wire to the machine battery's

positive (+) terminal and the black wire to the negative (-) terminal.

Run the communication cable with the 7-pin connector to the mast

location where the BULLSEYE 3 receiver is to be mounted. Secure

the cables with tie wraps ensuring that there is excess cable at all

moving joints of the machine and near the BULLSEYE 3 for adjust-

ment.

Remove the batteries from the BULLSEYE 3 and attach to the mast

as described in the operating section of the receiver. Plug the cable

connector into the connector on the bottom of the receiver and tighten.

Turn the Remote Display on using the power on / off switch. The

BULLSEYE 3 will also turn on when the remote is turned on.

Remote Display Model 14

Operation

The Remote Display has an internal dip switch panel located inside

the housing that controls certain receiver settings. Default settings

set from the factory are shown below. When the remote display is

turned on, the default settings are used. The settings on the

BULLSEYE 3 can still be changed as normal. Not all switches are

used for the BULLSEYE 3.

The factory default settings are switch number 1 and 2 On; switch

number 3 through 8 Off.

SWITCH # ON POSITION OFF POSITION

1 Receiver Display On Display Off

2 Receiver Display Bright Display Dim

3 Out-of-Level Enabled Out-of-Level Disabled

4 [Not Used] Center "On-Grade"

5 Extra Wide Deadband [Not Used]

6 Wide Deadband Standard Deadband

7 [Not Used] Beam Averaging = 4

8 [Not Used] Beam Averaging = 2

Remote Display

1 2 ... 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Apache Technologies Bullseye 3 Manual del operador Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor Apache Technologies Bullseye 3