Apache Technologies Bullseye 3 Manual del operador descargar pdf (Pagina 6)

Operation

To turn the BULLSEYE 3 on, press the power button on the touch

panel and hold down for 2 seconds. All the LED's will light for a few

seconds and then each row will light from top to bottom. If the

BULLSEYE 3 is out of the laser beam, the center LED will flash to

confirm power is on. If the BULLSEYE 3 is in a laser beam, a

corresponding LED grade display will be indicated.

Power On / Off

Display

Brightness

Deadband

Selection

Touch Panel

Default Settings. Each time the BULLSEYE 3 is turned on, certain

default settings are enabled. They are:

Deadband (Accuracy) = Standard

Display = Dim

Laser Out-of-Level = Disabled

To change the settings, press the corresponding switch as described

in the following section.

BULLSEYE 3™

Operation

Deadband (Accuracy) Selection. When the unit is turned on, the

deadband is in the Standard Mode. No LED is displayed. To identify

which mode is selected, press the deadband selection switch once.

The current mode is lit. To change the deadband, press the deadband

selection switch again when a deadband LED is lit. The deadband and

corresponding LED will change and cycle with each press.

Fine

Deadband

3/16"

(0.20"/5mm)

3 Channel Display

Standard

Deadband

1/2"

(0.45"/12mm)

5 Channel Display

Wide

Deadband

1-1/4"

(1.35"/34mm)

5 Channel Display

Brightness Selection. The brightness switch controls the LED

display brightness. When the receiver is first turned on, the default

setting is on Dim. Bright and Dim are the selection options. Use Bright

for daytime operation if necessary and Dim for lower light conditions.

Display Dim will conserve battery life by approximately 50%.

When the switch is depressed with the receiver out of the laser beam,

the LED's will display a circle with the current setting. Depress the

brightness switch again when these LED's are lit to change the

setting. The LED's will then display the new setting. When the receiver

is in the laser beam, simply depress the brightness switch and the

setting will change.

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Apache Technologies Bullseye 3 Manual del operador Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor Apache Technologies Bullseye 3