
BULLSEYE 3™
8
Low Battery Warning. The BULLSEYE 3 has a low battery warning
LED that is used when batteries are installed. During normal operation
with good batteries, the LED is off. When the batteries become low,
the LED will begin to flash, and the unit will operate as normal, with
approximately 90 minutes of battery life remaining.
When the batteries are too low to operate, the LED will be on
continuously and the four corner display LED's will toggle on and off.
The unit will no longer receive laser signals and the batteries must be
replaced.
Low Battery Warning LED
Operation
The LED grade displays indicate when the machine's cutting edge
needs adjusting or is on-grade. The display will indicate with
directional arrows which way to move the cutting edge or bucket to
achieve desired grade.
On-GradeHigh-
Lower
Implement
Fine High-
Lower
Implement
Fine Low-
Raise
Implement
Low-
Raise
Implement
BULLSEYE 3™
9
Operation
Out Of Level Warning. The BULLSEYE 3 is equipped with a laser
"out of level" (OOL) warning that is used with certain lasers. The
receiver can be set to display an OOL warning when it senses laser
rotation at 300 RPM. To activate the OOL warning, press the Display
Brightness and Deadband switches simultaneously. A flashing "X"
indicates the out of level alert is activated. Press the two switches
again to turn the warning off.
Sequence to lower implement Sequence to raise implement
Out of Beam Indication. The LED display will indicate if the
BULLSEYE 3 has moved beyond the vertical reception range. A
sequence of LED's will indicate which direction the cutting edge must
be moved to pick up the beam. The sequence will indicate to move the
edge down if it is raised above the beam. The sequence will indicate
to move the edge up if it is lowered below the beam.
Laser Out of Level
LED Display
Comentarios a estos manuales