Apache Technologies Bullseye 3 Manual del operador descargar pdf (Pagina 5)

BULLSEYE 3™

Battery Installation / Charging

Alkaline Battery Installation: Remove the BULLSEYE 3 from its

carrying case. Hold the unit so the accessory connector is pointing

upwards. Remove the dust cap from the accessory connector.

Loosen the two thumb screws and remove the battery access cover.

Install four “C” cell alkaline batteries as shown on the label diagram

inside the battery compartment noting the (+) and (-) terminals.

Replace the battery access cover. Firmly tighten the two thumb-

screws. Replace the accessory connector dust cap.

Nickel Metal Hydride Batteries: If the receiver is equipped with

rechargeable batteries, they require an initial and subsequent charg-

ing time of approximately 3 hours. It may require 2 or 3 charging

cycles to obtain maximum battery life. To charge, remove the dust

cap from the accessory connector. Insert the cannon adapter into the

accessory connector and tighten. Insert the charger into the cannon

adapter. Plug the charger into a 110-volt outlet. (European and

Australian chargers allow plugging into appropriate outlets.)

Battery installation diagram /

Serial number label

Cannon Adapter

Charger

The batteries may also be recharged with a 12-volt auto cigarette

lighter adapter. The charge status indicator located on the back of the

housing will remain solid when the unit is charging. The indicator will

blink when fully charged. When charged, unplug the charger from the

outlet and remove the cannon adapter from the accessory connector.

BULLSEYE 3™

Battery Installation / Charging

Built-in overcharging protection prevents damage if the unit is left on

charge after being fully charged. There is also charge protection for

attempting to charge alkaline batteries. However - DO NOT ATTEMPT

TO CHARGE ALKALINE OR OTHER DISPOSABLE BATTERIES.

NOTE: DO NOT CHARGE Ni-MH BATTERIES WHEN AMBIENT

TEMPERATURE EXCEEDS 113 F° (45C).

The rechargeable battery package includes a charge error indicator.

A solid light on the right LED indicates an error with either the internal

battery connection, the charging temperature, or possible dead

battery cell. Contact your dealer service department if this light is

displayed.

Charge Status

Indicator

Charge Error

Indicator

Rechargeable Battery Replacement - Remove the battery access

cover as previously described. A battery contact is located in the

battery housing as illustrated. For proper operation, a negative end of

one rechargeable battery must have the protec-

tive cover removed or "skinned" and positioned

to touch the contact in the housing as illus-

trated. Once installed, replace the battery ac-

cess cover, firmly tighten the two screws and

replace the dust cap. Charge as instructed on

page 4.

Battery Contact

Rechargeable Battery

Cover Removed

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Apache Technologies Bullseye 3 Manual del operador Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor Apache Technologies Bullseye 3